I've struggled with appropriate wire-to-board connections over the years.Here's one of OMSI's mainstays that I've co-opted that I'd like to share: all you do is Step 1: add a hole in your printed circuit board Step 2: route the wire through the holeStep 3: solder the wire to the boardin this case it...
By: hydronics
Continue Reading »
from Instructables: exploring - technology - robots http://ift.tt/1tCXafF
By: hydronics
Continue Reading »
from Instructables: exploring - technology - robots http://ift.tt/1tCXafF
0 comments:
Post a Comment