Friday, 20 March 2015

Arduino: Sending Digital Output

02:19  Telli k  No comments

In this lesson you will wire up an Arduino with a single LED and a 560 Ohm resistor then code and upload the firmware that writes sequential on/off commands to make the LED blink. This is the 'Hello, World' of Arduino.While this lesson could be done using the onboard LED, one of the objectives of th...

By: dseven3



Continue Reading »



from Instructables: exploring - technology - robots http://ift.tt/1FIJPMY

Posted in: ,

0 comments:

Post a Comment